Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
395
You display this setting and other information with the show ipsec conn-phase1 command.
You disable the use of the default list with the
no default-ciphers command.
With this command, you configure the number of repetitions for a failed connection
establishment.
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Call up the command with the following parameters:
ike-keytries <num(0-100)>
The parameter has the following meaning:
num Period for DPD queries Enter the required number.
With 0 there is no limit to the
number of attempts to establish
The number of times configured.
You display this setting and other information with the show ipsec conn-phase1 command.
With this command, you configure a period to specify the lifetime of the agreed keys. When
the time expires, the key is renegotiated.
To Next Page
Loading...
Need help?
General
