Siemens SCALANCE S615 - Icmp Name Set

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
316 Configuration Manual, 06/2015, C79000-G8976-C406-02
Syntax
Call up the command with the following parameters:
no icmp {name <string(255)> | all}
The parameters have the following meaning:
Parameter
Description
Range of values / note
name
Keyword for ICMP service name -
string
ICMP service name Specify a valid service name.
Maximum of 255 characters
all
Deletes all ICMP service names
-
Result
The corresponding ICMP service is deleted.
Further notes
You create the ICMP service with the icmp name command.
You display the available service names with the
icmp show-names command.
You show the available ICMP packet types and codes with the
icmp show-types-codes
command.
9.2.4.3
icmp name set
Description
With this command, you change the ICMP packet type and the code.
Requirement
● The corresponding ICMP service is has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
icmp name <string(255)> set type <num(0-256)> code <num(0-256)>