Siemens SCALANCE S615 - Ipsec VPN; The Show Commands; Show Ipsec Conn-Authentication; Show Ipsecvpn Connections

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
355
9.3
IPsec VPN
This section describes commands relevant for IPsec.
9.3.1
The "show" commands
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
Example
do show cli-console-timeout
9.3.1.1
show ipsec conn-authentication
Description
This command shows the security settings of the IPsec VPN connections.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
show ipsec conn-authentication
Result
The settings are displayed.
9.3.1.2
show ipsecvpn connections
Description
This command shows the configuration of the IPsecVPN connections.