Network protocols
6.5 DNS
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
211
With this command, you specify a manually configured DNS server. A maximum of three
DNS servers can be configured.
You are in the DNS CLIENT configuration mode.
The command prompt is as follows:
cli(config-dnsclient)#
Call up the command with the following parameters:
manual srv <ip_addr>
The parameter has the following meaning:
Enter a valid IPv4 address.
The DNS server is configured.
You display this setting and other information with the show dnsclient informationen
command.
You configure the DNS server type with the
server type command.
You delete the DNS server with the
manual command.
Interface identifiers and addresses (Page 25)
no manual srv
Description
With this command, you delete a specific DNS server or all DNS servers.
To Next Page
Loading...
Need help?
General
