Network protocols
6.3 DHCP client
SCALANCE S615 Command Line Interface
188 Configuration Manual, 06/2015, C79000-G8976-C406-02
Call up the command with the following parameters:
renew dhcp [{vlan<vlan-id(1-4094)>|<interface-type><interface-id>}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Auto-
Hotspot".
The IP address is assigned again.
This address can be a different address from the previously assigned address.
You can display the statistical information of the DHCP client with the show ip dhcp client
stats
command.
You show the statistical information and the configuration of the IP interface with the
show ip
interface
command.
Interface identifiers and addresses (Page 25)
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General
