Siemens SCALANCE S615 - Show Ip Interface; Show Versions

Configuration
2.1 System
SCALANCE S615 Command Line Interface
44 Configuration Manual, 06/2015, C79000-G8976-C406-02
2.1.1.10
show ip interface
Description
This command shows the configuration of one, several or all IP interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip interface
[{
vlan <vlan-id(1-4094)> |
<interface-type> <interface-id> |
loopback
}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 ... 4094
interface-
type
Type or speed of the interface Enter a valid interface.
interface-id
Module no. and port no. of the interface
loopback
Loopback
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available IP interfaces.
Result
The configuration of the selected IP interface is displayed.
2.1.1.11
show versions
Description
This command shows the versions of the hardware and software of the device.