Siemens SCALANCE S615 - Show Firewall Ip-Services

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
312 Configuration Manual, 06/2015, C79000-G8976-C406-02
The parameters have the following meaning:
Parameter
Description
Range of values / note
show-ifids
Lists the available interfaces.
-
all
Shows the information for all interfaces. -
if-id
Number corresponding to a specific
interface.
Specify a valid number.
Result
The predefined IPv4 rules are displayed.
9.2.2.6
show firewall ip-services
Description
This command shows the configured IP services.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
show firewall ip-services
Result
The configured IP services are displayed.