Siemens SCALANCE S615 - No Protocol-Vlan

Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
150 Configuration Manual, 06/2015, C79000-G8976-C406-02
5.1.2.6
no protocol-vlan
Description
With this command, you disable the protocol-based classification on all interfaces.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no protocol-vlan
Result
The classification is disabled.
Further notes
You enable the setting with the protocol-vlan command.
You can display the status of this function and other information with the
show vlan device
info
command.