Siemens SCALANCE S615 - No Service

Network protocols
6.5 DNS
SCALANCE S615 Command Line Interface
218 Configuration Manual, 06/2015, C79000-G8976-C406-02
The parameters have the following meaning:
Parameter
Description
Range of values
show-
services
Lists the available providers. -
index
Number corresponding to a specific provider.
Specify a valid number.
Result
The specified entry is enabled.
Further notes
You display this setting and other information with the show ddnsclient information
command.
You disable an entry with the
no service command.
6.5.5.2
no service
Description
With this command, you disable the dynamic DNS provider.
Requirement
You are in the DDNS Client configuration mode.
The command prompt is as follows:
cli(config-ddnsclient)#
Syntax
Call up the command with the following parameters:
no service {show-services | <index>}
The parameters have the following meaning:
Parameter
Description
Range of values
show-
services
Lists the available providers. -
index
Number corresponding to a specific provider.
Specify a valid number.
Result
The specified entry is disabled.