Configuration
2.1 System
SCALANCE S615 Command Line Interface
40 Configuration Manual, 06/2015, C79000-G8976-C406-02
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
Shows the description of the interface
Shows the status of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameters from the parameter list, the status and configuration of
all available interfaces will be displayed.
The status and the configuration of the selected interfaces are displayed.
This command shows information on device-specific vendor and maintenance data such as
the article number, serial number, version numbers etc.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show im
The information is displayed.
To Next Page
Loading...
Need help?
General
