Siemens SCALANCE S615 - Dpd-Period

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
390 Configuration Manual, 06/2015, C79000-G8976-C406-02
Further notes
You display this setting and other information with the show ipsec conn-phase1 command.
You enable DPD with the
dpd command.
9.3.7.7
dpd-period
Description
With this command, you configure the period after which DPD queries are sent.
Requirement
● DPD is enabled
● You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Syntax
Call up the command with the following parameters:
dpd-period <sec(10-120)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
sec
Period for DPD queries Enter the period of time in sec-
onds.
Result
The period of time is configured.
Further notes
You display this setting and other information with the show ipsec conn-phase1 command.
You enable DPD with the
dpd command.