Siemens SCALANCE S615 - Idle Timeout Udp

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
319
cli(config-fw)#
Syntax
Call up the command with the following parameters:
idle timeout icmp <second(1-4294967295)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
second
Interval in seconds
1 ... 4294967295
Result
The interval is configured.
Further notes
You display this setting and other information with the show firewall information command.
9.2.4.7
idle timeout udp
Description
With this command, you configure the required period for UDP. If no data exchange takes
place, the UDP connection is terminated automatically when this time has elapsed.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
idle timeout udp <second(1-4294967295)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
second
Interval in seconds 1 ... 4294967295