Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
341
The parameters have the following meaning:
Keyword for the interface
Type or speed of the interface Specify a valid interface.
Interface index Specify a valid interface
index.
Enables the predefined firewall rule on all inter-
-
Enables the predefined firewall rule.
Disables the predefined firewall rule.
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode".
The predefined firewall rule SNMP is enabled on the relevant interface. Incoming SNMP
connections are possible via the interface.
You display this setting and other information with the show firewall pre-rules ipv4
command.
You list the available interfaces with the
prerule ipv4 show-int command.
Commands in the FIREWALL configuration mode (Page 313)
prerule ssh ipv4
Description
With this command, you enable the predefined firewall rule SSH on the selected interface.
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
To Next Page
Loading...
Need help?
General
