Siemens SCALANCE S615 - Firewall; Introduction to the Firewall Section; The Show Commands; Show Firewall Icmp-Services Ipv4

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
309
9.2
Firewall
9.2.1
Introduction to the Firewall section
This section describes commands relevant for the firewall.
9.2.2
The "show" commands
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
Example
do show cli-console-timeout
9.2.2.1
show firewall icmp-services ipv4
Description
This command shows the configured ICMPv4 services.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
show firewall icmp-services ipv4
Result
The configured ICMPv4 services are displayed.