Siemens SCALANCE S615 - No User-Account; Username

Security and authentication
9.1 User rights management
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
307
9.1.4.2
no user-account
Description
With this command, you delete a user.
Note
Apart from the users "admin" and "user", they can all be deleted.
Requirement
● The user has been created.
● The user is logged in with the "admin" role.
● You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no user-account <user-name>
The parameter has the following meaning:
Parameter
Description
Range of values / note
user-name
User name
Enter a valid user name.
Result
The user has been deleted.
Further notes
You create a user with the user-account command.
You show the created users with the
show user-accounts command.
9.1.4.3
username
Description
With this command, you change the password of the factory set user "admin".