Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
156 Configuration Manual, 06/2015, C79000-G8976-C406-02
no map subnet
Description
With this command, you remove a subnet from a VLAN.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
no map subnet <ip-subnet-address>
The parameters have the following meaning:
Enter a valid subnet address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The subnet with subnet mask and subnet address is assigned to a VLAN.
You configure the setting with the map subnet command.
You can display the status of this function and other information with the
show subnet-vlan
mapping
command.
To Next Page
Loading...
Need help?
General
