Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
425
Call up the command with the following parameters:
client config {syslog|trap|email|all}
The parameters have the following meaning:
Enables the client that sends the messages to the Syslog server
Enables the client that sends the SNMP traps
Enables the client that sends the e-mails
Enables all clients at once
The function of the client selected for the transfer is enabled.
You display the status of the events and the clients with the show events config command.
You disable a client with the
no client config command.
no client config
Description
With this command, you disable one of the clients that processes or forwards the messages
of the device.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
no client config {syslog|trap|email|all}
The parameters have the following meaning:
Disables the client that sends the messages to the Syslog server
Disables the client that sends the SNMP traps
To Next Page
Loading...
Need help?
General
