Siemens SCALANCE S615 - No Shutdown

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
365
Requirement
● The VPN remote stations have been created and are not being used anywhere.
● You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Syntax
Call the command without parameter assignment:
no remote-end all
Result
All VPN remote stations are deleted.
Further notes
You display the VPN remote station with the remote-end name command.
9.3.3.9
no shutdown
Description
With this command, you enable the IPsec method for VPN.
Requirement
You are in the IPSEC configuration mode.
The command prompt is as follows:
cli(config-ipsec)#
Syntax
Call the command without parameter assignment:
no shutdown
Result
The IPsec method is enabled.
Further notes
You disable the IPsec method with the shutdown command.