Siemens SCALANCE S615 - Logon Show-IDX; Shutdown

Functions specific to SCALANCE
3.4 SRS
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
107
3.4.3.9
logon show-idx
Note
This command is only available with a KEY
-PLUG.
Description
With this command, you display the available destination servers.
Requirement
You are in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Syntax
Call the command without parameter assignment:
logon show-idx
Result
The destination servers are listed.
Further notes
You create a destination server entry with the logon addr command.
3.4.3.10
shutdown
Note
This command is only available with a KEY
-PLUG.
Description
With this command, you disable the use of SRS.
Requirement
You are in the SRS configuration mode.
The command prompt is as follows: