Siemens SCALANCE S615 - Prerule Tftp Ipv4

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
343
Syntax
Call up the command with the following parameters:
prerule telnet ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Parameter
Description
Range of values / note
int
Keyword for the interface
-
interface-type
Type or speed of the interface Specify a valid interface.
num
Interface index Specify a valid interface
index.
0 ... 10
all-int
Enables the predefined firewall rule on all inter-
faces.
-
enabled
Enables the predefined firewall rule.
-
disabled
Disables the predefined firewall rule.
-
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode (Page 313)".
Result
The predefined firewall rule Telnet is enabled on the relevant interface. Unencrypted access
to the CLI is possible.
Further notes
You display this setting and other information with the show firewall pre-rules ipv4
command.
You list the available interfaces with the
prerule ipv4 show-int command.
9.2.4.32
prerule tftp ipv4
Description
With this command, you enable the predefined firewall rule TFTP on the selected interface.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#