Siemens SCALANCE S615 - No Switchport

Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
160 Configuration Manual, 06/2015, C79000-G8976-C406-02
5.1.3.6
no switchport
Description
With this command you configure the interface as a router port. This disables all switching
and layer 2 functions.
Requirement
● The Interface is shut down.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport
Result
The interface is configured as a router port. Activate the interface again.
Further notes
You shut down the interface with the shutdown complete command.
You activate the interface with the
no shutdown command.
You configure the interface as a switch port with the
switchport command.
You display the status of this function and other information with the
show
interface
command.