Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
405
With this command, you specify the protocol for which the VPN connection is valid.
● The VPN connection region is assigned a VPN remote station.
● You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs2)#
Call up the command with the following parameters:
proto {all|<integer(0-255)>}
The parameter has the following meaning:
Applies to all protocols.
Protocol number Enter the number for the required
protocol.
You will find list of the protocol
numbers on the Internet pages of
The protocol is configured.
You display this setting and other information with the show ipsec conn-phase2 command.
You assign a VPN remote station to the VPN connection with the
rmend name command.
To Next Page
Loading...
Need help?
General
