Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
403
You display this setting and other information with the show ipsec conn-phase2 command.
You disable the use of the default list with the
no default-ciphers command.
With this command, you configure a period to specify the lifetime of the agreed keys. When
the time expires, the key is renegotiated.
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs2)#
Call up the command with the following parameters:
lifetime <min(10-16666666)>
The parameter has the following meaning:
Period Specify the period of time in
The period of time is configured.
You display this setting and other information with the show ipsec conn-phase2 command.
To Next Page
Loading...
Need help?
General
