Network protocols
6.1 IPv4 protocol
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
185
You delete the settings with the no ip address command.
You display this setting and other information with the
show ip interface command.
no ip address
Description
With this command, you delete the assignment of an IP address to a VLAN interface.
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Call up the command with the following parameters:
no ip address [{ <ucast_addr>}]
The parameter has the following meaning:
IP Address of the VLAN interface that will
enter a valid IP address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The assignment of the IP address to a VLAN interface is deleted and DHCP is disabled.
Note
Effectiveness of the command
The command is effective immediately.
If you configure the interface via which you access the device, you can lose the connection!
You configure the setting with the ip address command.
You display this setting and other information with the
show ip interface command.
To Next Page
Loading...
Need help?
General
