Siemens SCALANCE S615 - Loc-Subnet

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
373
Requirement
You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(onfig-conn-X)#
Syntax
Call up the command with the following parameters:
k-proto {ikev1|ikev2}
The parameters have the following meaning:
Parameter
Description
Range of values / note
IKE1
Uses IKEv1
-
IKEv2
Uses IKEv2 -
Result
The setting is configured.
Further notes
You display this setting and other information with the show ipsec connections command.
9.3.5.3
loc-subnet
Description
With this command, you configure the local subnet.
Requirement
You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(config-conn-X)#
Syntax
Call up the command with the following parameters:
loc-subnet <subnet|dns>