Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
415
With this command, you show the messages that occurred in the firewall. The messages can
be filtered according to the event severity.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show fwlog [{ info | warning | critical }]
The parameters have the following meaning:
If you use the command without setting parameters, all messages are displayed.
The content of the firewall log is displayed.
With this command, you display the content of the logbook.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
