Siemens SCALANCE S615 - Commands in the Interface Configuration Mode; Ip Address

Network protocols
6.1 IPv4 protocol
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
183
Result
The Telnet server is disabled.
Further notes
You enable the Telnet server with the telnet-server command.
6.1.3
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
6.1.3.1
ip address
Description
With this command, you assign an IP address to a VLAN interface.
Requirement
You are in the Interface configuration mode of VLAN or a router port and DHCP was
disabled with the
no ip address command.
The command prompt is as follows:
cli(config-if-vlan$)#
or with a router port:
cli(config-RPort-if-Int$-$)
Syntax
Call up the command with the following parameters:
ip address <ip-address> {<subnet-mask>|/<prefix-length(0-32)>}[secondary]