Siemens SCALANCE S615 - No Remote-End Name; No Remote-End All

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
364 Configuration Manual, 06/2015, C79000-G8976-C406-02
9.3.3.7
no remote-end name
Description
With this command, you delete a specific VPN remote station.
Requirement
● The corresponding VPN remote station has been created and is not being used
anywhere.
● You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Syntax
Call up the command with the following parameters:
no remote-end name <name(128)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
name
Name of the VPN remote station Enter the name of the VPN re-
mote station.
Result
The corresponding VPN remote station is deleted.
Further notes
You create the VPN remote station with the remote-end name command.
9.3.3.8
no remote-end all
Description
With this command, you delete all VPN remote stations.