Siemens SCALANCE S615 - Show Firewall Ip-Rules Ipv4; Show Firewall Pre-Rules Ipv4

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
311
9.2.2.4
show firewall ip-rules ipv4
Description
This command shows an overview of the IPv4 firewall rules.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
show firewall ip-rules ipv4
Result
The overview of the IPv4 firewall rules is displayed.
9.2.2.5
show firewall pre-rules ipv4
Description
This command shows the predefined IPv4 rules available on the interface.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show firewall pre-rules ipv4 {show-ifids|all|<if-id>}