Siemens SCALANCE S615 - Device Pw

Functions specific to SCALANCE
3.5 SINEMA RC
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
115
3.5.4.5
device pw
Note
This command is only available with a KEY
-PLUG.
Description
With this command, you configure the password with which the device logs on to the
SINEMA RC Server. The password is assigned when configuring the device on the SINEMA
RC Server. You will find further information on this in the Operating Instructions of the
SINEMA RC Server.
Requirement
You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Syntax
Call up the command with the following parameters:
device pw <password(256)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
password
Device password Enter the password.
Maximum of 256 characters
Result
The device password is configured.
Further notes
You display this setting and other information with the show sinemarc command.