Security and authentication
9.1 User rights management
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
305
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you specify a new user. You can also change the password / role of an
already created user.
● If the logged in user has the "admin" role, he or she can create a new user or change the
password / role of a user.
● When the logged in users have the "user" role, they can can only change their password.
up to 16 additional user accounts.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
user-account <string> password <passwd> privilege {user | admin}
The parameters have the following meaning:
User name Enter a user name. The name must be
To Next Page
Loading...
Need help?
General
