Siemens SCALANCE S615 - Show Ip Routing; Show Ip Static Route

Network protocols
6.1 IPv4 protocol
SCALANCE S615 Command Line Interface
174 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.1.1.5
show ip routing
Description
This command shows whether or not the "routing" function is enabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip routing
Result
The routing function is enabled.
6.1.1.6
show ip static route
Description
This command shows the routes that were generated statically.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip static route
Result
The static routes are displayed.