Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
372 Configuration Manual, 06/2015, C79000-G8976-C406-02
Commands in the IPSEC CONNECTION configuration mode
This section describes commands that you can call up in the IPSEC CONNECTION
configuration mode.
In the IPSEC configuration mode, enter the
connection command to change to this mode.
● If you exit the IPSEC CONNECTION configuration mode with the
exit command, you
return to the IPSEC configuration mode.
● If you exit the IPSEC CONNECTION configuration mode with the
end command, you
return to the Privileged EXEC mode.
authentication
Description
With this command, you change to the IPSEC AUTHENTICATION configuration mode.
You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(config-conn-X)#
Call the command without parameter assignment:
authentication
You are now in the IPSEC AUTHENTICATION configuration mode.
The command prompt is as follows:
cli(config-conn-auth)#
You exit the IPSEC AUTHENTICATION configuration mode with the end or exit command.
With this command, you specify whether IKEv2 or IKEv1 will be used.
To Next Page
Loading...
Need help?
General
