Layer 3 functions
8.1 NAT
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
293
Number of the addressed VLAN
Number corresponding to a specif-
ic NAPT rule. Specify a valid num-
ber.
0 ...200
The specified NAPT rule is deleted.
You display the numbers of the NAPT rules with the napt show-idx command.
You delete all NAPT rules with the
no napt all command.
You create a NAPT rule with the
napt type ipv4 command.
With this command, you delete all NAPT rules.
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Call the command without parameter assignment:
no napt all
All NAPT rules are deleted.
You create a NAPT rule with the napt type ipv4 command.
To Next Page
Loading...
Need help?
General
