Configuration
2.2 Load and Save
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
69
This section describes commands for displaying, copying, saving and downloading files for
the device.
Note
Note that during the installation of a previous version, the configuration data can be lost. In
this case, the device starts up with the factory configuration settings after the
firmware has
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
show loadsave files
Description
This command shows the current Load&Save file information.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show loadsave files
The current Load&Save file information is displayed.
To Next Page
Loading...
Need help?
General
