Siemens SCALANCE S615 - Verification Cacert

Functions specific to SCALANCE
3.5 SINEMA RC
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
121
3.5.4.11
verification cacert
Note
This command is only available with a KEY
-PLUG.
Description
With this command, you specify the CA certificate of the server used to sign the server
certificate.
Requirement
● The certificate is loaded.
● You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Syntax
Call up the command with the following parameters:
verification cacert [<name(256)>]
The parameter has the following meaning:
Parameter
Description
Range of values / note
name
Name of the server certificate Enter the name of the server
certificate.
Maximum of 256 characters.
Result
The CA certificate of the server is configured.
Further notes
You load certificates with the tftp load command.
You display this setting and other information with the
show sinemarc command.