Configuration
2.2 Load and Save
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
79
With this command, you disable the password for a file.
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Call up the command with the following parameters:
no password {showfiles|filetype<filetype>}
The parameters have the following meaning:
Shows the available files
Shows that the file type follows that will be loaded
The password for the file is disabled.
You enable the password for the user certificate with the password command.