Siemens SCALANCE S615 - Syslogserver

Diagnostics
10.2 Syslog client
SCALANCE S615 Command Line Interface
434 Configuration Manual, 06/2015, C79000-G8976-C406-02
10.2.2.1
syslogserver
Description
With this command, you configure the Syslog server address.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli (config-events) #
Syntax
Call up the command with the following parameters:
syslogserver {ipv4 <ucast_addr> | fqdn-name <FQDN>} [<port(1-65535)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
ipv4
Keyword for an IP address
-
ucast_addr
Syslog server IPv4 Address
Enter a valid IPv4 address.
fqdn-name
Keyword for a domain name
-
FQDN
Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
port
Serverport 1 .. 65535
Default: 514
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The settings for the Syslog server are configured.
Further notes
You disable the setting with the no syslogserver command.
You can display the status of this function and other information with the
show events config
command.