Siemens SCALANCE S615 - No Static-Lease

Network protocols
6.4 DHCP server
SCALANCE S615 Command Line Interface
206 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.4.3.10
no static-lease
Description
With this command, you delete the assignment of an IPv4 address to a MAC address.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no static lease mac <mac-address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
mac-address
Unicast MAC address
Specify a valid MAC address.
Result
The assignment is deleted.
Further notes
You configure the assignment with the static-lease mac command.