Configuration
2.1 System
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
51
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
coordinates height
Description
With this command, you enter a height coordinate.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
coordinates height <meter>
The parameter has the following meaning:
Input box for the height coordinate max. 32 characters
To use spaces in the entry, enter
the height coordinate in quotes:
coordinates height "123 456"
The height coordinate is created.
To Next Page
Loading...
Need help?
General
