Siemens SCALANCE S615 - Page 427

Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
427
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
event config
{ cold-warmstart | linkchange | authentication-failure | power-change | faultstate-
change | digital-in | vpn-tunnel | all}
{logtable | syslog | email | trap | faults | digital-out | vpn-tunnel | all}
The parameters have the following meaning:
Parameter
Description
cold-warmstart
Message if there is cold or warm restart
linkchange
Message when there is a status change on a physical interface
authentication-failure
Message if there is an incorrect login
power-change
Message when there is a status change in the power supply
faultstate-change
Message when there is a status change in the error monitoring
digital-in
Message when there is a status change of the digital input
vpn-tunnel
Message when there is a connection change (OpenVPN, IPsec,
SINEMA RC)
all
All messages
logtable
Client that processes the log entries
syslog
Client that sends the messages to the log server
email
Client that sends the e-mails
trap
Client that sends the SNMP traps
faults
Error LED lights up. The setting is possible only for a cold or warm
restart.
digital-out
Controls the digital output or signals the status change with the
"DO" LED.
vpn-tunnel
Controls the VPN connection (establishment/termination).
all
All clients at once
Result
The setting deciding which message of the device is stored or forwarded is configured.
Further notes
You display the status of the events and the clients with the show events config command.
You delete the settings with the
no event config command.
With this command, the clients are not enabled.