Siemens SCALANCE S615 - Page 242

Network protocols
6.6 SNMP
SCALANCE S615 Command Line Interface
242 Configuration Manual, 06/2015, C79000-G8976-C406-02
Parameter
Description
Range of values
ipv4
Keyword for an IPv4 address
-
IPAddress
Value for an IPv4 unicast address Enter a valid IPv4 unicast address.
timeout
Keyword for the time the SNMP
agent waits for a response before it
repeats the inform request message
-
Seconds
Time in seconds
1 ... 1500
retries
Keyword for the maximum number of
attempts to obtain a response to an
inform request message
-
RetryCount
Number of attempts
1 ... 3
taglist
Keyword for tag list
-
TagIdentifier
Tag identifier that selects the desti-
nation address for SNMP.
Specify the tag identifier.
none
No tag identifier
-
volatile
nonvolatile
Specifies whether the settings re-
main following a restart.
•
volatile:
The default settings are used af-
ter a restart.
•
nonvolatile:
The saved settings are used af-
ter a restart.
port
Keyword for the port number at
which the SNMP manager receives
traps and inform messages
-
integer
Port number
1 ... 65535
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If optional parameters are not specified when configuring, the following defaults apply:
Parameter
Default value
taglist
snmp
Type of storage
volatile
port
162
Result
The SNMP target address is configured.
Further notes
You delete the SNMP target address with the no snmp targetaddr command.
You display the SNMP target address with the
show snmp targetaddr command.
You configure the SNMP target parameters with the
snmp targetparams command.
You display the SNMP target parameters with the
show snmp targetparam command.