Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
167
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Call up the command with the following parameters:
ports
(
[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
)
[
untagged<interface-type> <0/a-b,0/c,...>
(
[<interface-type><0/a-b,0/c,...>] [all]
)
]
[
forbidden<interface-type><0/a-b,0/c,...>
[<interface-type><0/a-b,0/c,...>]
]
[name<vlan-name>]
The parameters have the following meaning:
Type or speed of the interface
Specify a valid interface.
Port no. of the interface
Keyword for interfaces or ports that transfer
data packets without VLAN marking
-
Specifies that all interfaces or ports are set to
-
Keyword for forbidden interfaces or ports
Keyword for the name assignment
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The settings are enabled.
You display details of the function with the show vlan command.
You reset the settings with the
no ports command.
To Next Page
Loading...
Need help?
General
