Customer specific functions Instruction manual GLM-I
102 38.019.129.001 en
10
10 Customer specific functions
10.1 Approve or block key programming
If you approve key programming, this function is no longer available.
–
Record macro and open via a key, see page 106
– Set up customer-specific model level T, see page 120
– Rename softkey, see page 102
– Assign image to softkey, see page 103
– Set up quick keyboard, see page 119
The following settings are available for key programming:
"Disab.": Key programming is blocked.
"Enab.": Key programming is approved.
Mode level: 5
<Etc> / <Device operation>
Touch <Key programm.> until the required setting is displayed.
10.2 Renaming soft keys
With only a few exceptions, you can rename softkeys to call up simple functions as you
wish. The following types of softkeys in particular cannot be renamed
:
Softkeys to start functions, e. g. <Release total>
Softkeys to access menu levels
Softkeys to access tables
Modified softkey labels can be replaced at any time either temporarily or
permanently by standard labeling
, see page 98.
Approve key-programming, see page 102.
Select mode level.
Open the menu level for the softkey you want to change.
Press <Alt> and <Record>.
From the "Edit softkey design:" menu, select and confirm the "Modify softkey text"
function.
Press the key you want to change.
If you are not permitted to change the name, a message is displayed "Changing soft-
key texts not permitted.". When you acknowledge the message
, the function is ended.
If you are permitted to change the name, an input field appears.
Enter the relevant text and confirm your input.
To Next Page
Loading...
Need help?
General
