Bizerba GLM-I User Manual

Accessories Instruction manual GLM-I
452 38.019.129.001 en
31
31.13.2 Enter paper size
Mode level: 5
<Etc> / <List printer>
The following settings are possible:
–
<Paper length>
– <Upper page margin>
– <Lower page margin>
Press the required softkey.
Enter value and confirm input.
31.13.3 Paper take-up: Endless or single page
Mode level: 5
<Etc> / <List printer> / <Paper feed>
The setting changes every time you press the key.
31.13.4 Printer settings
The interface settings for the printer can be reviewed and edited in one of the following ta-
bles:
<Set parameters>:
Table with individual settings
<Default parameters>: Table with standard settings
Mode level: 5
<Interfaces> / <EDP interface> / <Serial interf. settings> / <ListPrinter parameters>
Select and confirm table.
A table appears with interface settings for the printer.
Adjust settings if necessary.
Save table and exit, see page 85.
31.14 Tendency control
The tendency control function requires the "TENDENCY CONTROL" li-
cense.
The tendency control is used to control a customer-side dosing, transporting or slicing de-
vice in relation to the statistical mean value of the weighed packages
. Any deviations to
the mean value can be corrected directly via outputs.
Enter the required specifications in tables. These tables are assigned to articles via the pa-
rameter numbers.

Bizerba GLM-I Specifications

General

Brand	Bizerba
Model	GLM-I
Category	Label Maker
Language	English