Bizerba GLM-I - Printing Table Data

Instruction manual GLM-I Display and operating unit
38.019.129.001 en 83
7
7.7.4 Printing table data
The data of a table editor can be printed for controlling or archiving purposes on blank la-
bels, ticket rolls or lists.
To make available the keys that are necessary to release the print,
make sure the additional keys at the bottom frame edge are shownbe-
fore opening the table
, see page 66.
Minimum width of empty labels or ticket rolls used:Standard printing of editor data re-
quires empty labels or ticket rolls with a width of 68 mm
. Blank labels and ticket rolls with a
width of 58 mm can only be used when setting a smaller character set.
Please contact your Bizerba consultant or Bizerba Service for further in-
formation.
Preparing printing on blank labels
To avoid that the labels need to be removed constantly, cut off backing paper under-
neath the printer before starting printing and lead it out of device
.
After the final label was printed, cut off the backing paper and remove the label strip
as an entire piece
.
Then, properly insert backing paper again into printer and take-up unit.
Preparing printing on ticket roll
Mode level: 2
Insert a ticket roll into the labeler instead of backing paper.
<Labels> / <Printer menu> / <Etc> / <Print out- put to ...>
Select and confirm "Ticket w/o preprHead".
After printing insert backing paper again into labeler and re-establish
the previous setting of print output (standard setting
: "Lab.w. backing
paper").