Display and operating unit Instruction manual GLM-I
84 38.019.129.001 en
7
Preparing list printing
A list printer is connected to labeler.
Mode level: 2
<Printer + interface> / <List printer> / <Deviating print service print>
Press <List print. interface>.
After printing switch print routing again to previous setting (standard set-
ting: <Label printer
>).
Starting to print
You need the following keys:
<Print>
Generates print.
<Print>
Starts printing.
Data are displayed in a table editor.
Printing on blank labels
, ticket roll or lists was prepared.
Before opening the table editor the additional keys were shown with the key <Two lines>
at the lower screen edge, see page 66.
Press <Print>.
Press <Print>.
Table data are printed.
To Next Page
Loading...
