Instruction manual GLM-I Accessories
38.019.129.001 en 441
31
31.10.3 Display
The display shows the various parameters and the status. After switching on, the program
version number and program date are displayed
.
This function disappears after a few sec-
onds or can be deleted by confirming it us-
ing a key.
Illustration 93: Version and date
The displayed standard text is the MODE text. The status of the label dispenser, the num-
ber of dispensed labels and the current program number are displayed here
.
Switch between the parameters by pressing
the <UP> or <DOWN> keys.
Illustration 94: Standard text
Changing the mode
The label dispenser can be operated in different modes
. Change the mode by pressing the
<MODE – ENTER> key.
The following modes are available:
–
"READY"
– "PAUSE"
Illustration 95: Change mode
"READY" The label dispenser emits a label when the product sensor is
activated.
"PAUSE" The label dispenser does not emit any label when the product
sensor is activated.
If the label dispenser is set to the "PAUSE" mode, use the
<START – STOP> key to activate it.
If a system is provided with two label dispensers, the "STANDBY" mode is also available.
The label dispenser in
"STANDBY" mode is designed as redundant system and remains in
"STANDBY" mode until the other label dispenser reports error. In the event of an error, the
label dispenser in "STANDBY" mode is automatically set to "READY".
To Next Page
Loading...
Need help?
General
