To Next Page

To Previous Page

Instruction manual GLM-I Codes and scanning rules

38.019.129.001 en 227

19.3.8 Delete code structure rule

Delete the code structure rules you no longer require.

Mode level: 3 (local) or 4 (global)

Enter and confirm code structure number, see page 77.

In order to delete the code structure rule, answer security check with <yes>.

19.4 Load code structure rule into code field

When using standard labels, you can only print a barcode in code field 1. Depending on

the layout you can print barcodes in up to seven code fields on customer labels.

Allocation of code structure rules to the individual code fields is usually handled in PLU da-

ta and is called up together with the PLU. With this function you can enter or change the

allocation for the current labeling job.

Example: Code field 1. The procedure for other code fields is the same.

Mode level: 2

Enter and confirm the number of the code field in which you want to print the code

structure rule, see page 77.

19.5 Enter or change the code substring for the current labeling job

In code strings you can enter all kinds of data such as PLU number, manufacturer number,

etc.

Comply precisely with the number of digits dictated by the code struc-

ture rule when entering the code substrings

. If a code substring is lon-

ger than is permitted by the code structure rule, only the permitted num-

ber of digits will be printed, starting at the beginning. If a code substring

is too short, processing is blocked.

Code substrings are usually entered in PLU data and called up together with the PLU.

With this function you can enter the code substring for the current labeling job directly or

temporarily change the code substring that was called up with the PLU. If necessary, you

can apply your entries to PLU data.

Example: Code substring 1. The procedure for con substrings 2 to 7 is the same.

Mode level: 2

Enter value. Comply with the number of digits dictated by the code structure.

To apply the value to the PLU data, activate the field "->Database [Etc]" .

If the field is not activated, the value is only used for the current labeling job.

Bizerba GLM-I User Manual

Questions and Answers: