Instruction manual GLM-I Back up data
38.019.129.001 en 369
27
27.1.3 Load line backup
Only load a line backup back to the line where it has come from.
Requirements:
–
The devices are connected with each other via the system bus.
– The devices are switched on.
– Automatic processing has stopped.
– Mode level: 5
Make sure that the storage medium is inserted in device.
<Storage medium> / <Line backup> / <Load line>
Select a line back-up and press <ok>.
The following message appears: "When loading setups, the backup setup is auto-
matically activated and the devices are switched off
/on.".
Press <ok>.
The following question appears: "Adopt only local master data?".
Load local or all master data
Only load local master data: Select "yes" and press <ok>. Continue with "Which attrib-
ute configuration do you wish to use for database
?".
or
Load all master data: Select "no" and press <ok>.
Re-create master data or add
Re-create master data, overwrite master data on device: Select "Create" and press
<ok>. Continue with "Which attribute configuration do you wish to use for database
?".
or
Add master data to existing master data: Select "Add" and press <ok>.
A table occurs. The table columns contain the devices that belong to the line. The ta-
ble rows contain different data groups. You can select the device from which you want
to save data. Continue with "Select data".
"Which attribute configuration do you wish to use for database?"
Load attribute configuration from line backup: Select "Use from data backup" and
press <ok>.
or
Keep attribute configuration of devices: Select "Device configuration maintained" and
press <OK>.
A table occurs. The table columns contain the devices that belong to the line. The ta-
ble rows contain different data groups
. You can select the device from which you want
to save data. Continue with "Select data".
To Next Page
Loading...
